![]() The channel width used for these depends on this configuration. Specifies the high throughput mode, used to control 802.11n (HT), 802.11ac (VHT) and 802.11ax (HE). Specifies the band, possible values are 2g for 2.4 GHz, 5g for 5 GHz, 6g for 6 GHz and 60g for 60 GHz. ( DEPRECATED since 21.02.2, replaced with band) Note that 11ng, 11na, 11n and 11ac are invalid options, this setting should largely be seen as controlling the frequency band. Channels can be provided as range using hyphen ('-') or individual channels can be specified by space (' ') separated values. This option allows hostapd to select one of the provided channels when a channel should be automatically selected. Use specific channels, when channel is in “auto” mode. “auto” defaults to the lowest available channel, or utilizes the ACS algorithm depending on hardware/driver support. Removing this option or setting it to 0 will enable the adapter Specifies the radio adapter associated to this section, it is not used to change the device mac but to identify the underlying interface.ĭisables the radio adapter if set to 1. If present, it is usually autodetected and should not be changed. Specifies the radio phy associated to this section. Used values are broadcom on brcm47xx, or mac80211 for all other platforms The type is determined on firstboot during the initial radio device detection - it is usually not required to change it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |